Portal for car enthusiasts

"Mitsubishi Pajero", 3rd generation: description, specifications, photos

In 1999, the presentation of the new Mitsubishi Pajero car (3rd generation) took place. Immediately after the debut in Japan, the serial production of this brand was launched. Three years later, the company carried out a restyling, but not deep. Basically, the changes were limited to updating the appearance. In 2006, the Pajero 3 assembly was discontinued in favor of the fourth generation.

Briefly about the main

So what is the third generation Pajero? This is a typical SUV with a frame integrated into the body. During the release, the model was presented with both three and five doors. In accordance with this, the first version of the "Pajero 3" is designed for five seats, the second - for seven. On the road, the car demonstrates high levels of aerodynamic properties. It allows you to use the car both in urban conditions and off-road.

Drivers and passengers note the high level of cabin comfort. While driving, even on the worst roads, the car goes smoothly, vibration is not felt. It is also worth noting that the level of sound insulation is quite acceptable - extraneous noise from the street and from the operation of the engine in the cabin are almost inaudible. In a word, it comprehensively demonstrates excellent Japanese quality.

Dimensions

Since the third generation Pajero was produced with different body modifications (three- and five-door), naturally, the dimensions of the car are somewhat different. For example, the length of a five-seater starts at 4220 mm, but the Pajero, which is designed for seven people, reaches 4800 mm. The width of both copies is the same and is 1825 mm. As for the height, there are different indicators. They vary in the range from 1845 to 1855 mm.

I would like to pay special attention. After all, in SUVs this parameter is considered one of the most important. It is thanks to him that this demonstrates a high rate of patency. So, in the Mitsubishi Pajero 3, the clearance is 230 mm with a disc radius of 17 inches.

Exterior

The exterior design of the car is no less important than the technical characteristics. It is unlikely that anyone will want to purchase a model if its design elements are completely unsatisfactory. However, looking at this full-size SUV, it's hard to imagine that someone might not like it.

Model "Pajero 3" - the car is quite large. This type is suitable only for those who prefer large cars. Its exterior is very attractive and, it is worth noting, is still relevant. In the front, a voluminous bumper immediately catches the eye. On its sides are round foglights. The optics of the head light resembles a rectangle, but with smoother lines. made in the form of an inverted trapezoid. In the middle of it flaunts the company logo.

What do we see in the back of the Mitsubishi Pajero 3? First of all, a large tailgate. It flaunts a spare wheel, slightly shifted to the right, and a license plate on the left. The bumper is small. It has rectangular and rather narrow feet on the sides. Slightly above the headlights, they are extended from top to bottom.

Interior

Now it's time to look into the salon. The first thing I would like to immediately note is the spaciousness. The seats are quite comfortable in all rows. The rear sofa has a division into a single and double chair, which is why it will be quite comfortable for three adults to fit on it. In the seven-seat model, the third row of seats is a little cramped.

The luggage compartment has a minimum volume of 215 liters, but it can be significantly expanded with rear seats. If you completely remove the second and third rows of seats, then the capacity of the cargo compartment increases to almost 1800 liters.

As for the control panel, at the moment it can hardly be called multifunctional. The steering wheel is not equipped with buttons, some of them are located on the driver's door. limited to the base radio. Those cars that were intended for sale in the Arab countries had two air conditioners in the kit. One functioned taking into account the blowing of the front seats, the second - the rear. And the copies produced for the domestic market were equipped with a stove instead of a second air conditioner.

Pajero 3 engines

"Pajero" (third generation) was produced with gasoline and diesel units. The line of the first was represented by installations for 3.0-3.8 liters. The power they provided ranged from 173 to 208 "horses". Russian buyers could only purchase a car with a 3.5-liter V6 engine. It provided 202 hp. However, it is worth noting that the installation turned out to be quite demanding on the quality of gasoline, so it caused a lot of trouble for the owners.

Diesel engines installed on Pajero 3 (the price of such models is currently about 500 thousand rubles) are also represented by several modifications. The line includes installations from 2.5 to 3.2 liters. In comparison with gasoline units, they show less power (105-165 horses). Their disadvantage can be called the same problem that gasoline engines have - the requirement for high quality fuel.

Advantages and disadvantages

Finally, I would like to highlight the advantages and disadvantages of the Mitsubishi Pajero 3 model. Undoubtedly, the advantages include the following indicators:

  • high level of permeability;
  • comfort and spaciousness of the cabin;
  • aerodynamic properties;
  • quality materials;
  • great design.

There are not many cons in the car. First of all, it is expensive maintenance and high price for spare parts. Some drivers also note the poor performance of the "climate control" system, which malfunctions in severe frosts.